MixW - delay after TX going back to RX

[W9YK]

New set up - MixW on the computer, loaded fine, used my registration key, worked fine, with a new interface between rig (Icom 756-Pro 3) and computer, (PC) - using BuxComm Rascal II plus (USB Sound Card) - got the audio to be seen by the computer (MixW prints to screen) - got the rig to go into TX - can send info (made a few RTTY contacts) BUT here's the rub - after finishing the outgoing message, and either clicking the ESC key or the RX on the MIxW screen - there is a lag of almost 2 seconds before MixW starts to read the signals - this lag, especially in a contest environment is counter productive - On the rig, I do not have VOX ON, and even experimented by bringing the timing of the VOX delay on the rig to zero - and still the delay going from TX to RX - btw, goes to TX from RX instantly - Have used MixW and recognize this behavior is abnormal - just can't find a way to get it back to a quick switch back to RX from TX - Also, this behavior started right from install - so it was that I set something (though anything is possible.) Any one have a clue what might be wrong? Appreciate some assistance.

E F Todd Benson, W9YK Elmhurst, IL

[VE7LGP]

Hey Todd I Use this prog on a 133 Mhz computer without problems.
If you are using Macros remember to ad the <RX> to the end of the line to switch automaticly back to recieve Mode!
Make sure echo is disabled in your PTT Hardware menu.
Lloyd VE7LGP