Power Indicator

[KN7S]

There is no "power" box when you first enter a QSL. When you look at the record prior to editing/saving, there is a "power" box. I tried putting a new value in "power", but it always defaulted to "0".

[K2DSL]

It carries the power forward for my call by not the new operators call. I need to go to their tab each time and enter the power. But if I log a contact with 100w on my call, the next log record remembers my 100w. I can also go to the other ops tab and enter in a power level and it takes it. What are the exacts steps where it shows a 0 after you enter a value?

[KC4TVZ]

Here is a Power Photo.
It defaults to 0.

73 KC4TVZ Todd

[AA7BQ]

I was thinking of making 100W the default for the contacted station.

The logging station side seems to be OK.

Could also default to the same power as the last contacted station,

Which would be preferred?