w4ass
09-11-2008, 05:55 PM
1 WRITE DOWN ALL OF YOUR SETTINGS IN THE MENU SYSTEM ON PAPER BECAUSE IT WILL BE LOST AFTER CPU RESET
2.Disconnect the radio from all power ,accessories,and antennas prior to attempting this modification
3.use a grounded low power thermo control soldering iron.
4 turn the radio over and take off the back cover .locate the control board (right front corner)you will see 9 jumpers ,marker 1 through 9 add a soder bridge to pad number 5 .
5 reassemble the radio
6 do a full reset by holding the FAST and LOCK buttons in while pushing the POWER switch to on
7 the "TX" RANGE IS NOW 1.8-30MHZ AND 50-54 MHZ
GOOD LUCK AND AND AS ALLWAYS YOU DO THIS AT YOUR OWN RISK
2.Disconnect the radio from all power ,accessories,and antennas prior to attempting this modification
3.use a grounded low power thermo control soldering iron.
4 turn the radio over and take off the back cover .locate the control board (right front corner)you will see 9 jumpers ,marker 1 through 9 add a soder bridge to pad number 5 .
5 reassemble the radio
6 do a full reset by holding the FAST and LOCK buttons in while pushing the POWER switch to on
7 the "TX" RANGE IS NOW 1.8-30MHZ AND 50-54 MHZ
GOOD LUCK AND AND AS ALLWAYS YOU DO THIS AT YOUR OWN RISK